IODINE ADSORBER FILTER
IODINE FILTER-ADSORBER PHAG-83
The filter-adsorber PHAG-83 is part of the special gas purification system at nuclear energy use facilities (OIAE).
TITLE
The adsorber filter is designed to reduce radioactive emissions into the atmosphere by chromatographic sorption of inert radioactive gases, as well as purification from radioactive iodine compounds at nuclear energy facilities.
The filter adsorber PHAG-83 is located in the controlled access zone and corresponds to the climatic design "T", the placement category "4", the type of atmosphere "IV" (according to the requirements of GOST 15150).
Environmental parameters at the location of the adsorber filter:
- temperature from 12 to 50 ° C;
- humidity up to 100%.
The filter-adsorber functions in all modes of normal operation of the OIAE, including start and stop, operation at power, transient modes.
SPECIFICATIONS
Nominal performance of the adsorber filter by air, нм3/ч 83 Aerodynamic resistance to the flow of purified air at a flow rate of 60 н3/ч, Pа, не более 2 500 Operating temperature of the cleaned air at the inlet, °С от +13 до +50 Sorption capacity (adsorption coefficient) of activated carbon
under normal conditions, ml/g (м3/м3), nevertheless
- for Kr-85
- for Xe-133
66(33)
1260(630)Efficiency of air purification from molecular iodine at nominal capacity, %, nevertheless 99 Bulk density of the sorbent, kg/м3, nevertheless 500 The volume of the sorbent VSK-5 or CarboTech DGF 10х18/65, м3 4 Working pressure, mPa 0,05 Weight, kg, не более 3400
IODINE FILTERS
HAVEN’T FOUND A REQUIRED FILTER?
If you failed to find a filter that would fit your parameters, we can manufacture it specially for you!